Re : Trouble interfacing Linkam PE94 with labview

[aimee123]

Hi everyone,

I am trying to use labview 2013 as an interface for a Linkam PE94 temperature controller via a RS232 cable.

I can read from the instrument using the "T" command and a simple read/write program. However, I cannot get it to accept commands that control settings such as the heating rate command ("R1") or  temperature limit command ("L1").

Has anyone had a similar problem or perhaps could suggest where I might be going wrong? Any help is appreciated!

Best regards,

Aimee 

PS Then manual for the temperature controller can be found here

 http://forums.ni.com/ni/attachments/ni/250/69925/1/serial%20commands%20for%20t92-t93-t94%20100%20ram...

[sabri.jatlaoui]

HI aimee 123,

Check thist forum, it might help.

http://forums.ni.com/t5/Multifunction-DAQ/LabVIEW-8-5-and-Linkam-Stage/td-p/1928555

Regards.

[aimee123]

Thanks Sabri,

I have seen this forum and tried to use the .vi attached within it. My instrument only responds to the T command. If I run the vi.s that tell the instrument to start ("S") or to set the temperature limit nothing happens - I don't get an error message - just no reaction from my instrument.

I can set the parameters from the front panel and use labview to record the temperature remotely but ideally I would like to controll everything from labview.

Thanks for your suggestion,

Aimee