10-15-2014 06:00 AM
Hello,
I want to run NI USRP Example LabVIEW VI from the below link. But I do not have MIMO cable. So I want to know what are the main things I have to consider if I want to eliminate the MIMO cable and use just the antenas for transmit and receive?
Do I need to make any changes in the VI or not?
Please guide.
Thank you,
JK
10-16-2014 04:58 PM
Hi Joseph,
Firstly, what USRP are you using and are you trying to do any synchronization?
Can you tell me a bit more about your application? Are you specifically interesting in video transmit or are you looking for a general example for Tx/Rx with USRP or USRP RIO?
10-25-2014 07:38 AM
I am using USRP 2920 but instead of USRP 2920 daughter baord we have LFTX and LFRX daughter boards, which has a carrier frequency of 0 to 30MHz. I am specifically interested in video transmission between one USRP to another USRP and I wanto to connect both USRPs with different laptops. So can you guide me how can I run the above mentioned video transmission example VI in this case.
Thanks
JK
10-27-2014 06:01 PM
The example you linked has different vi's for transmission and receiving, so if you want to run this with USRP's on different systems I imagine you would run the transmission vi on one system and the receiving on another. I'm not familiar with the programming needed for MIMO so unfortunately I can't tell you what you would have to change to not use it. I would assume that if you were not using MIMO you could start with a simpler USRP transmit or receive vi example and go from there.