turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Discussion Forums
- :
- Most Active Software Boards
- :
- LabVIEW
- :
- Re: Saving initial values (values from first iteration) of a 4-element 1D array so i can use them for arithmetic operations for values from succeeding iterations

Topic Options

- Start Article
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

03-29-2010 02:33 PM

Im trying to save/put in memory the first iteration values of a 4-element 1D array and use them to do arithmetic operations on the initial and succeeding values of the same array.

Here's what i'm trying to do:

Let's say the first iteration results to an array with values (2, 4, 6, 8)

Second iteration values = (4, 8, 12, 16)

Third iteration values = (6, 12, 24, 48)

The resulting array will display:

1st iteration = (2, 4, 6, 8) divided by (2, 4, 6, 8) = __(1, 1, 1, 1)__

2nd iteration= (4, 8, 12, 16) divided by (2, 4, 6, 8) = __(2, 2, 2, 2)__

3rd iteration = (6, 12, 24, 48) divided by (2, 4, 6, 8) = __(3, 3, 4, 6)__

Any help would be appreciated and Thanks in advance!

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

03-29-2010 02:43 PM

I just finished writing a VI that does something very similar. The new array changes everytime the VI is accesed. It compares the previous array to the new array and calculates values. Ignore my label for the output array. It could be misleading. The output array is the result from my calculation. The first time through it compares the new array to a default value, then each successive time the new array is compared to the previous array that was run the last time through. Hope this makes sense. See attached.

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

03-29-2010 02:47 PM

sorry but my version of Labview is 8.0

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

03-29-2010 02:59 PM

This question is similar to this one

Highlighted
# Re: Saving initial values (values from first iteration) of a 4-element 1D array so i can use them for arithmetic operations for values from succeeding iterations

Options

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

03-30-2010 07:22 AM