06-14-2012 08:10 AM
I just ran my LabVIEW FPGA project on my computer , and later I terminated the LabVIEW process since something is wrong, my computer didn't respond.
Then I opened the same project again , and LabVIEW keeps reminding me this ,as shown in the picture below.
It says "LabVIEW : Resource not found",and "LabVIEW load error"
How can I recover this vi ? or do something else to reload this vi? cause it's a little complicated and really cost me some time , I hope I don't have to do the whole thing again!
Thank you !!!
06-14-2012 08:16 AM
This may be due to problem in the communication between the Host and the Target. Try to find the target in MAX and Restart it.
06-14-2012 08:36 AM
Firstly, thank you for your attention!
I just restared my computer and refreshed my target in MAX, but it still dosen't work and reminds me that problem.
This problem had never happened to me before, mostly LabVIEW would remind me "Recover" and everything goes fine, this time it really got me.