06-11-2015 10:18 AM
Hi Folks.
This is probably an obvious one but I cant figure it out. In the sine wave detector VI attached the peaks are determined from a simulated signal. I want to be able to do the same with a waveform data (DBL) but it wont let me. How can I extract the signal from the DBL to feed to the rest and make the waveform peak detector VI work right??
Thanks,
Mark.
Solved! Go to Solution.
06-11-2015 10:49 AM
Use From DDT, found on the Signal Manipulation Palette, to change the Dynamic wire into a Waveform.
Bob Schor
06-11-2015 11:05 AM
Thanks Bob.
That did the trick.