05-10-2016 08:54 AM
Hello,
For a school project I'm trying to get a MLX90164 IR-thermo sensor working with a MyRIO-1900 via Labview..
However I can not get it to work.. The sensor is connected via the SCL and SDA port on the MyRIO.
I managed to read the slave address with an Arduino-controller. Because we are making a complete system i need to read the temperature with LabVIEW.
I've searched the internet and found out that the sensor can be read via I2C, because i have not enough knowledge about these adresses and SMBus I am stuck.. My question is, if someone would like to help me out a bit, so I can read the sensor with LabVIEW via the MyRIO..
The slave adress is 0x5A and the datasheet of the sensor is included.
Any help would be very appreciated concerning the required VI...
This is the link to the sensor i bought:
http://www.hackerstore.nl/Artikel/629
This is the datasheet that comes with the sensor:
http://www.hackerstore.nl/PDFs/IRTempSensor.pdf
Kind regards,
Lars de Vries
Stenden Hogeschool Emmen
05-10-2016 02:43 PM