08-22-2014 10:26 AM
Thank you, is there a way to use the counter as my timebase?
If I understand correctly, the counter uses ticks or ms? Is it possible to read out the counter then have an event occur?
Something like:
If Counter<= PO:4 HIGH
Else PO:4 LOW
08-22-2014 10:27 AM
08-22-2014 10:41 AM
That may be what I have to do.
What I did yesterday was:
Wired (physically) CTR0 to AI1
In NIMax I chose Analog I/O, and selected AI1. Selected on-demand.
Right now, using the 'Counter-Finite Output.vi', I use the CTR0 to trigger a pulse: Frequency: 1; Duty Cycle: 0.50
Watching NIMax I see that the counter is operating properly, so that works...
I need to figure out how to keep the pulse HIGH for an certain amount of time. Not sure how I would go about that...
08-22-2014 10:48 AM
09-04-2014 09:49 AM
How to access gpio pins(sbrio 9606) from RT side.It is possibal?how?
09-04-2014 09:49 AM
How to access gpio pins(sbrio 9606) from RT side.It is possibal?how?
09-04-2014 10:37 AM
I think you posted in the wrong thread bub?
09-05-2014 05:46 AM
There is 0-95 DIOS in sbrio 9606 apart from this there is 22 GPIO port which are connected to processor.i am trying to access this GPIO port(Not FPGA DIOs) from RT side.I am applying 5v across any one port pin now this 5v is act as a trigger for me when this 5v is detected on RT labview program i will do some proccess.can you plz tell how we can read this 5v inside RT program from GPIO(not FPGA DIOs 0-95) port pin?
09-05-2014 06:10 AM