06-05-2015 07:51 AM
Hi All,
Is it possible to add a "target" position to a guage indicator? For example, I am using a gauge indicator to indicate temperature from 0-100C. The process target is some temperature X (variable), I would like to programmably add a small mark or "tick" at the target temperature to indicate that it is the target temperature. See the attached picture for a quick example of what I am trying to do.
Thanks!
Andrew
06-05-2015 10:28 PM
06-06-2015 08:21 AM
06-06-2015 08:35 AM
06-06-2015 09:11 AM
so, by using 2nd needle?
06-06-2015 09:51 AM
06-07-2015 05:28 AM
two solutions, edit a new control or use second needle...
Best regards
06-08-2015 07:45 AM
Thanks for all the replies. These solutions will work.