12-05-2013 12:31 AM
Hi my friends and Labview Application Engineers,
I need help urgently.
I need to map my table control into a multicolumn listbox.
However, I get Error 1057 as shown in attached photo.
How should I get rid of the error? Thank you very much!
12-05-2013 01:08 AM
12-05-2013 01:12 AM
Thanks for your previous reply udka.
However, that link didnt help at all.
How do I refresh my post so that more people can view and perhaps get more response ? Sry for reposting.
12-05-2013 01:27 AM
12-05-2013 03:20 AM
Hey pokerprof
would it possible to get the VI
It would help debug the problem faster 🙂
12-05-2013 04:12 AM
Hello guys,
Thank you for your reply.
Sorry I could not release the VI over here.
I shall close this post and accept no solution.
Cheers !