01-03-2013 07:58 AM
Hello there,
Just like the title already says, I have some software that a person before me made using the cRIO 9101.
Every time I try to open the software it is asking me to point out some .ctl files.
When I am searching after them on my hard disk, I am selecting them.
And every time I select the EIOXNodeErrorStruct.ctl then the labview gives the error I attached and just closes...
Is there anybody who ever had something like this?
What should I do against it?
Thanks in advance for the help.
01-14-2013 06:50 AM - edited 01-14-2013 06:51 AM
Hello J.Willems,
Do you have information about the LabVIEW version in which the original application was made?
Do they use self-made XNodes in this application?
Is it possible to share the application/code with me?
Which NI software set-up are you using?
If you could share a MAX Report with me, then this might provide me with some valuable information:
http://digital.ni.com/public.nsf/allkb/271F252B4EF0A2E0862570E70056A1E4?OpenDocument
01-14-2013 06:59 AM
Hello ThiChop,
I completly reinstalled my labview setup, and now the problem is solved.
The persons from NI Belgium think it is there was a problem with one of the dependencies.
Now I can open and run the program.
Thanks for the reply.
01-14-2013 06:59 AM
Hello ThiChop,
I completly reinstalled my labview setup, and now the problem is solved.
The persons from NI Belgium think it is there was a problem with one of the dependencies.
Now I can open and run the program.
Thanks for the reply.
01-14-2013 08:47 AM
Hello J.Willems,
Thanks for letting me know!
Alot of success with all your programming!