LabVIEW

[UdeS]

Hello,

I have to realize a LabView program to command a step by step motor.

My problem is that the command sent to the motor is not the instruction I give to the program. I found that the error is made when the data are converted from graphics to analog data.

I don't understand what is the problem. Is the problem comes from the functions I use to convert the data ? (see my attached picture of the program)

Thanking you

[CCornish · Accepted solution]

Try using a build array node in place of the build cluster node and convert from cluster to array node.

Normally, the data type to be expected by the Analog 1D Waveform N Channels N Samples VI is an array of waveforms.

Also, you do not include your basic DAQ setup in the image; it would be helpful to see how you are configuring the device.

[UdeS]

now you can see the entire program. Tell me if there is something wrong.

[macncheese]

Hello UdeS,

I found this example that maybe could help you.