07-16-2010 07:32 AM
I wrote a program (Labview 2009) and it runs fine on my PC.
After I compile it and try to run it on another PC (Dell Laptop) it cannot find my GPIB nor my serial device.
I have Measurement&Automation installed on the laptop and the GPIB device shows up and communicates from there.
I also have my serial device (a relay board) working from the relay board’s software.
I know the hardware is working but Labview doesn’t see them.
I get the error code 1073807202 for both the GPIB and serial device.
Help, please!
Thanks
Tony
Solved! Go to Solution.
07-16-2010 07:43 AM - edited 07-16-2010 07:44 AM
Hi,
Did you install the VISA Run-Time engine on your computer ? Also are you using NI Serial and GPIB (488.2) based hardware ? If this is the case, you have to install the NI Serial driver and NI 488.2 driver.
http://joule.ni.com/nidu/cds/view/p/id/2056/lang/fr
http://joule.ni.com/nidu/cds/view/p/id/1606/lang/fr
http://joule.ni.com/nidu/cds/view/p/id/1529/lang/fr
Regards,
07-16-2010 07:46 AM
Hi,
Thanks for the quick response.
I assumed the VISA runtime was included in the Labview Runtime Engine.
Am I incorrect?
Thanks,
Tony
07-16-2010 07:48 AM
Hi,
Wrong ! This is not included in LabVIEW RTE 😉
Regards,