Adding noise and waveform

meere · ‎05-19-2016

I'm trying to make a VI that shows how certain types of noise affect a signal. The result is not what I expected, any comments or recommendations to make it better? attached below is the vi

mikeporter · ‎05-19-2016

What is not meeting your expectations? And in what way?

Mike...

Certified Professional Instructor
Certified LabVIEW Architect
LabVIEW Champion

"... after all, He's not a tame lion..."

For help with grief and grieving.

meere · ‎05-19-2016

I was expecting a signal looking more like this

crossrulz · ‎05-19-2016

Use the Signal Processing->Waveform Generation VIs for your noise generation. They should use the same sampling info as your main signal.

There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5

meere · ‎05-19-2016

What operation did you use? that addition vi seemed different from thte one I used.. thank you for the help

crossrulz · ‎05-19-2016

The Add will show the error terminals when two waveforms are being added together. You will get an error if the data rates are different.

There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5

LabVIEW

Adding noise and waveform

Adding noise and waveform

Re: Adding noise and waveform

Re: Adding noise and waveform

Re: Adding noise and waveform

Re: Adding noise and waveform

Re: Adding noise and waveform