04-26-2017 05:51 AM
I have connected a easy-driver and a stepper motor through arduino. I made the programme with the help of LIFA stepper motor library. The stepper motor is working fine, but the problem is with the direction pin. Here I am attaching two programme, one made by me and another made by college. The "working.vi" programme is made by my college which is working as expected. The "Notworking.vi" is not working. It is always rotating clockwise. I have tried to figure out the difference between the two programme but I could not. Can anyone please find me what mistakes I made in the "Notworking.vi" programme.
Labview verson 2015
Thanks
Arpan
12-28-2017 03:20 PM
Hi
I am interested in same.
Can some one convert the examples for lb2013.
I put an example that i am working.
My final project will be a 2 modes working, automatic that i enter the number of pulses and it goes after pressing start. The other mode will be manual (here is my problem) I would like to press a clockwise buttom and it rotates if i release it stops and if i press a anti clockwise do the same in reverse.
Best
cpalha