02-28-2016 01:38 PM
Hi,
I have a Crio 9022 and the NI 9227 and NI 9225. I have Labview Development version, I do not have the FPGA nor the Electrical Power Suite. Can I still measure power from my system?
02-28-2016 07:37 PM
Hi,
If you want to utilize 9225/9227 to acquire the signals, you must insert them into one cRIO or cDAQ chassis. If you have only one 9022 controller, I am afraid you cannot use the 9225/9227. So firstly, you need to setup a full set of cRIO system.
For simple power measurement, the FPGA-based processing is not required. You could install Eletrical Power Suite (base version), and there is a palette "Basic Measurement". It is free and doesn't depend on FPGA. It includes the basic measurement VI for power (active power, inactive power, etc).
02-29-2016 02:53 AM