From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Additional NI Product Boards LabVIEW Communications System Design Suite Topic

LabVIEW Communications System Design Suite

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

scope setting for 2 channel configuration

scope setting for 2 channel configuration

‎03-16-2017 02:51 AM

Hey everyone,

I have a short (and perhaps simple) question:

If I want to configure both USRP Channel. Which command is my "scope"? In the manual is written, "tx/RF 0", "tx/RF 1", "rx/RF 0", "rx/RF 1". But can I also write "rx" or "rx/RF 0, rx/RF 1" to set up both channels?

 

Thanks.

0 Kudos
Message 1 of 2
(2,613 Views)
Reply

Re: scope setting for 2 channel configuration

‎05-01-2017 04:44 AM

Hi aschwind,

 

Can you please give the link of the manual that you are referring to?

 

Thanks,

0 Kudos
Message 2 of 2
(2,478 Views)
Reply