ericsson fusion splicer

[kerry]

I am looking for a labview driver for an ericsson 995fa fusion splicer, so that I can remotely access the built-in programs and write my own routines. Communication is over an rs232 port.

[LoganS]

Hi Kerry,

I've searched through our Instrument Driver Network for a driver for the Ericsson 995fa Fusion Splicer without success. I've also checked out Ericsson's website without being able to find any solution for you there. It looks like your best bet from this point is going to be to request a driver, if you haven't already. You can do this by going to the Instrument Driver Network, and following the link to "Request Drivers". Hopefully this helps you on your way. Good luck!

Logan Sheen
Applications Engineer
National Instruments