Is there a device driver readily available for Avtron drive Advantage32 in Labview. I am new to device driver, so please guide me.
I was trying to communicate with the drive using the RS232 link(There is a converter RS232-RS485),the drive end is RS485.I connected the TX1+,TX2-,RX1+,RX2- at the drive end.Gnd is not required?
Also at the Coverter end shorted 6&20 (25 pin).Also the start bit can't be configured in Labview.I am receiving some strange characters when sending a request(As per the Format).What can be the problem?