From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I tried to use a while loop in a subvi. I wired the conditional to the main vi throght the connector panel,but had problems. Is it possible to use a while loop in a subvi?
Hyatt, You may have better luck getting an answer to this if you post to the LabVIEW General forum.
However the reason this is not working is that when you call a SubVI the values from a Main VI are passed 1 time. Therefore you can not change the SubVIs stop terminal from the Main VI, by passing the boolean. You could do it with globals or passing by refernce.
