Facing Problem With PCAN DLL after creating installer

[Prabhakant_Patil]

Hi

I Have Developed to Test The CAN Hardware.

I am Using third party USB to CAN device (Phytec PCAN)

To communicate with PCAN device I have Used PCAN_USB.DLL

I have Tested My Code with the hardware. It Works Fine.

Then I Have Created EXE and Installer. and Install on the other system ( LabVIEW is not installed on that system). But it is not communication with the Hardware.

If I run the EXE on the system (where LabVIEW is installed) then EXE is communicating with the hardware.

Please guide me for the same. LabVIEW version - LabVIEW 2009

Please treats this on urgent Basis

Regards

Prabhakant Patil

[Prabhakant_Patil]

Hi

I Have Developed to Test The CAN Hardware.

I am Using third party USB to CAN device (Phytec PCAN)

To communicate with PCAN device I have Used PCAN_USB.DLL

I have Tested My Code with the hardware. It Works Fine.

Then I Have Created EXE and Installer. and Install on the other system ( LabVIEW is not installed on that system). But it is not communication with the Hardware.

If I run the EXE on the system (where LabVIEW is installed) then EXE is communicating with the hardware.

Please guide me for the same. LabVIEW version - LabVIEW 2009

Please treats this on urgent Basis

Regards

Prabhakant Patil

[sumit.sen]

Have you added the LabVIEW Real-Time engine in the installer?

[Dennis_Knutson]

I think sumit.sen means the run-time engine. That is required but so is your third-party diver. What exactly did you include in the installer? Is this dll included? Where did you install it?