Ethernet communication to NU-EP1 laser sensor controller

[producaosirmaf.pt]

I´m having the same or similar problem. 

I have a DL-EP1(ethernet/ip) connected to an ig1000 laser sensor and the DL-EP1 connects directly to the Pc without a PLC .

I have installed the Ni Industrial communications for ethernet/ip 14.0. (Labview 1013 sp2)

The indicators in DL-EP1 display:

Link/activity indicator (LINK/ACT) green Blinking - Link correctly established, and exchanging data. – OK

Module status indicator (MS) Green solid - The NU-EP1 is operating  correctly. – OK

Sensor communication indicator (D-bus)- Green solid - Communicating correctly.

Network status indicator (NS) Green Blinking - Connection is not established. - Check that the NU-EP1 is registered in the scanner. – NOK

How can I connect to DL-EP1 correctly?

Could you please help me.

Best Regards,

Valter

[dnchen]

Valter, 

If I understand correctly, your setup looks like this: NU-EP1 -> DL-EP1 -> PC

Which LabVIEW functions are you using to communicate to the DL-EP1?

[Hrdn]

Hi, I will be working with a very similar application. 

Have you been able to communicate with the Keyence Ethernet/Ip device? 

Do you have any suggestions?

[sankar06]

Hi, I to have same problem any suggestion or sample program for Ethernet/IP