Example Program Drafts

Showing results for 
Search instead for 
Did you mean: 

myRIO FPGA Sine Wave Sound Output

by MHutch ‎03-18-2014 10:38 AM - edited ‎01-27-2017 04:47 AM

Overview

This simple code shows how to output sound in the form of a sine wave to the audioout of the myRIO using the FPGA. The sine generation VI is configured with the appropriate bit type for the output specification of the myRIO, allowing a representative frequency range.

Description

Using simple scaling and the sine wave generator VI, it is relatively straightforward to output sound on the myRIO, using the FPGA.

Steps to Implement or Execute Code

  1. Place VI under myRIO FPGA target in a LabVIEW project
  2. Compile the VI
  3. Run the VI

Requirements

Software

NI LabVIEW 2013

Hardware

NI myRIO

Additional Images or Video


snipsnip.png

Comments
Lucas_Tadeu_Salomao
N/A

Hello,

I know exactly the same VI and I am getting an error when I analyze with the oscilloscope. The frequency is a bit above the set

I need to generate a 5Khz signal and when measure is going out 5800Hz.

Please I need help.

Contributors