09-21-2015 03:35 PM
I have engine data where I am measure pulsations in the fuel rails. The data is collected with an engine RPM sweep from 700RPM to about 4500RPM. I am most interested in viewing the time domain amplitude within a certain order range. For example, I would like to see only half to third order data. I am currently using Digital filters, and only looking at a section of my data at a time, so I was wondering if there is any way to digitally filter data based on order, rather frequency.
Thoughts?
09-22-2015 08:41 AM - last edited on 01-08-2024 01:48 PM by migration-bot
Hi Russell,
DIAdem has several order analysis functions you can use for this-- though the ANALYSIS dialogs are only available with the DIAdem Professional version. Have you tried the below posted application, which will work in any of the 3 DIAdem flavors?
https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000x14vCAA&l=en-US
Brad Turpin
DIAdem Product Support Engineer
National Instruments
09-22-2015 08:47 AM
Unfortunately, I do not have the professional version, and I use the linked program often (and learned how to do effecient rising edge detection with it, too). I will try to convince my managment to purchase the upgraded version.
Thanks.