DIAdem

cancel
Showing results for 
Search instead for 
Did you mean: 

Curve Transformation in Report

 I'm struggling to figure out how to use the curve transformation options in the report tab.

 

Basically I have some unfilterered channels that I would like to plot with a CFC1000 filter applied. This appears to be the option I need, select the channel, apply the filter to the channel only when it's plotted.

 

Any advice?

0 Kudos
Message 1 of 8
(3,518 Views)

The following DIAdem Help documentation for event definition provides some context for how to populate those fields.

 

'Event Definition'

http://zone.ni.com/reference/en-XX/help/370858M-01/dlgpresent/graph_dlg_menu/dlgeventparams_dialog/

 

Specifically, the event definition is tied to a user command. For example, if you select 'Current event definition (recommended)', DIAdem will execute the user command you put in the 'According to new definition' text box. For either option, the user command you select must already be registered with DIAdem.

0 Kudos
Message 2 of 8
(3,458 Views)

Thanks,

But that's not totally helpful. Anyone else?

0 Kudos
Message 3 of 8
(3,330 Views)

Hi Tamer,

 

Check out the shipping example, "Extracting Bits Using Curve Transformation".

 

Brad Turpin

DIAdem Product Support Engineer

National Instruments

0 Kudos
Message 4 of 8
(3,307 Views)

Thanks Bob,

 

I think this is a good starting point. It's a bit complex, but I'll see if I can dissect it to get it to do what I want.

 

 

0 Kudos
Message 5 of 8
(3,266 Views)

Bump. Anyone else have any ideas?

0 Kudos
Message 6 of 8
(2,968 Views)

What happened when you started from the shipping example recommended by Brad?

Highest Regards,

Paul
0 Kudos
Message 7 of 8
(2,954 Views)

I didn't have any luck getting it to work.

0 Kudos
Message 8 of 8
(2,949 Views)