03-28-2013 10:59 AM
I have changed my dasylab software to a another computer and cannot get a prevously functioning program to run.
Im using a MCC 1208FS daq with a digital input signalling the program measurment.
The message I get back from dasylab is as follows.
Relay
The time information or block length of the input channels do not match.
These channels cannot be linked in this module (Stop)
can anyone point me in the right direction here , I think it maybe a driver timebase setting is not specified correctly in the setup.
Thanks Kent.
03-28-2013 01:05 PM
Thanks Found the problem, I didn't have the channels in sync and had to enable the seperate handling of bits.