05-12-2015 04:20 PM
I am trying to use the Digilent Basys2 board with Multisim 13.0.1 and have followed the instructions at http://www.ni.com/white-paper/14871/en/.
However, when exporting to the PLD, Multisim does not recognize the BASYS2 board that is connected by USB (Device status: Not connected or drivers not installed). I have Xilinx ISE 13.1 and Digilent Adept 2.16 installed. Digilent Adept is able to recognize and communicate with the the BASYS2 board fine, but not Multisim.
Any suggestions?
07-06-2015 03:09 PM
Hi markmorin,
In order to program the Basys 2 from Multsim using Xilinx ISE 13.1, you will need to install a plugin from Digilent. It is a free install and it can be found here, along with instructions. Let me know if that works for you.
Jeff
National Instruments