From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards Multisim and Ultiboard Topic

Multisim and Ultiboard

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Where do I find DDF2Gencad converter v1.30?

Solved!
Go to solution

Where do I find DDF2Gencad converter v1.30?

‎11-19-2009 07:35 AM

I have been notified by the board house I use, that they are now using Aegis Industrial Software’s "CircuitCam".

This requires me to convert the conventional Ultiboard outputs using the "DDF2GenCAD converter v1.30", that

they claim is supplied by Ultiboard.I have searched high and low for this converter without success. Can you give

me any information regarding it? Thanks You very much, Tod

 

 

0 Kudos
Message 1 of 2
(3,730 Views)
Reply
Solution
Accepted by Todc.18

Re: Where do I find DDF2Gencad converter v1.30?

‎11-30-2009 02:02 PM

Hi Tod,

 

I'm guessing here, but that probably existed with Ultiboard 5. If it existed, it does not exist anymore.

Garret
Senior Software Developer
National Instruments
Circuit Design Community and Blog

If someone helped you, let them know. Mark as solved or give a kudo. 🙂
Message 2 of 2
(3,667 Views)
Reply