Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Problem in AC circuit with ammeter and inductance

Solved!
Go to solution
In AC circuit I have connected three virtual components: AC voltage power source (100Vrms, freq. 50Hz, phase 0), inductance (0.31831H) and ammeter in AC mode. After I turn on the cicruit ammeter display "1A". If I change phase in AC power source to 120 degrees, ammeter shows "0A". This problem exists in multisim 10.x and 11.0.
0 Kudos
Message 1 of 3
(4,001 Views)
Solution
Accepted by topic author somarek

Hello. I got it to work when i set "Initial Conditions" to "Set to zero".

 

Menu: Simulate/Interactive simulation settings/Defaults for transient analysis instruments/Initial conditions.

 

W.k.r.

0 Kudos
Message 2 of 3
(3,984 Views)

It's working 🙂

 

Thanks for your help.

0 Kudos
Message 3 of 3
(3,954 Views)