07-28-2014 02:52 PM
Hi Everyone,
I'm new to Multisim and these forums. I was hoping somebody could help me, I am trying to measure the s-parameters of this circuit I'm working on, but I can't figure out how to connect the network anaylzer. I tried reading the user guide but it's not much help, I have tried connecting it several different ways, and I get different results everytime.
I'm not sure if this matters but R1, R2 and C3 are the load. The rest is the matching network, and I want to measure the reflected power.
Thanks In Advance
07-31-2014 11:00 AM
Hi Nino,
I'm Chiara, an AE with NI UK.
I found this previous forum which seems to suggest an answer to your question: http://forums.ni.com/t5/Circuit-Design-Suite/How-do-you-connect-virtual-Network-anaylzer-in-a-two-po...
Hope this helps!
Best wishes,
08-01-2014 12:18 AM
Hi,
Thanks for the input, I had read that thread before but I don't undetrstand it, I'm not sure what a directional coupler is, and which ports I need to connect and where. But I appreciate the help.
Nino