Coaxial connector component in Multisim

[sien]

Hello,

     I have been looking for a coaxial connector component in the Multisim database as well as the components site listed here. But, I couldn't find one. Can anyone get me a hint about how to find it. Thanks.

[_user32 · Accepted solution]

sien,

There are several 2-pin connector symbols that you could use and attach them to the available Ultiboard footprints or custom BNC footprints based on what is needed, however here is a schematic with an example BNC connector with a standard BNC symbol configuration.

Feel free to save back to database and customize with any specific information (this was created for a 50 Ohm coax).

Regards,

Patrick Noonan
Business Development Manager
National Instruments - Electronics Workbench Group
50 Market St. 1-A
S. Portland, ME 04106
Email: patrick.noonan@ni.com
Tel. (207) 892-9130
Fax. (207) 892-9508 

[sien]

_user32

        Very helpful information. I think my Multisim and Ultiboard do not have any BNC component/footprint because it is an educational version (University licensed). I'll try to make one. Thanks

sien