NI Home
Cart Cart | Help
Hello Events Academic NI Developer Zone Support Solutions Products & Services Contact NI MyNI
You are here: 
 NI Home > NI Developer Zone > NI Discussion Forums

Circuit Design Suite (Multisim, Ultiboard)

turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Reply
Topic Options
Member kummmmari
Member
kummmmari
Posts: 2
0 Kudos

which tool uses Hspice simulator?

Options

‎07-23-2012 12:11 AM

which tool uses Hspice simulator? like orcad capture uses pspice engine...

Message 1 of 2 (220 Views)
 
Reply
Member Sharanya_R
Member
Sharanya_R
Posts: 58
0 Kudos

Re: which tool uses Hspice simulator?

[ Edited ]
Options

‎08-13-2012 10:18 AM - edited ‎08-13-2012 10:18 AM

Hello,

 

Unfortunately HSpice is not supported; Multisim can only read SPICE and PSPICE models.  You can create a component using the Component Wizard if you have a SPICE or PSPICE model.

Regards,

Sharanya R
Market Development Engineer
National Instruments
Message 2 of 2 (160 Views)
 
Reply
By using this web site, you accept the Terms of Use for this web site. Please read these Terms of Use carefully before using any part of this site. Please go here for information on ni.com's copyright infringement policy.
My Profile | Privacy | Legal | Contact NI © 2011 National Instruments Corporation. All rights reserved.    |    E-Mail this Page E-Mail this Page