04-10-2014 02:53 AM
Hi,
please, can I simulate USB port on Multisim ?
thank you
04-10-2014 03:23 PM
Hi,
For schematic capture purposes, there are some USB connectors in the Multisim Master Database, however, you can't use these for simulation. USB requires the use of a protocol and this is something not supported in a SPICE simulator. If you tell us more about your project we may be able to provide suggestions.
Best,
04-11-2014 01:00 PM
Hi, thank you for your reply
my project is simple I want just part of numeration at low speed transfer (HID protocol), may be I can control some leds later by microcontroller
thanks
04-13-2014 03:55 AM
Hi, Fernando D.
have you an Idea about my project ?
greeting
04-14-2014 08:44 AM
Hi,
As mentioned before, Multisim does not support the simulation of USB ports. Perhaps you could program the protocol using a microcontroller. In Multisim look for the MCU group in the Master Database. You will find some microcontrollers that can be programmed in C or assembly. There are a couple of examples in File>>Open Samples>>MCU.
Best,