05-21-2008 06:44 PM
05-21-2008 07:00 PM
05-21-2008 07:02 PM
I am not sure which version you have, but you need to look at the bottom of the screen. There should be a spreadsheet view done there. In this spreadsheet you will find a list of tabs. Goto the tab that is labeled "nets" and click it. Once there go to the right and find the column that says "routing layer" and see what it says. If you transfered from Multisim it will probably say "10" which means to route the copper top only.
To change this i use this technique. I go down selecting all the nets with SHIFT>Left Mouse button and then once they are all highlighted I click on one net in the column and then enter the following based upon which side of the board you want routed
10 Copper Top
01 Copper Bottom
11 Both sides
Once you change one using this technique all of them will be changed as a group.
This works for me in the Power Pro Version. if you have a different version then I will have to go back and re-investigate how this can be done without the spreadsheet.
I hope I have helped some.
05-22-2008 07:47 AM - edited 05-22-2008 07:47 AM
05-22-2008 05:37 PM
06-15-2012 05:04 PM
I was getting the same error, but for a 4-layer board. It appears that each digit represents a layer, a "1" indicates it is routable, and a "0" indicates that it is not. My existing status was 1001, which I changed to 1111 to enable routing on all layers.