07-10-2008 12:17 PM
07-11-2008 01:48 AM
Thank Ipshita_C for responding.
By da way I am using ECG Sensor from Vernier. I want to used NI9215 to acquire data from the sensor. There are 6 pins from the ECG Sensor. How I want to implement data acquisition using NI9215.
I attached here the respsctive connection for the ECG sensor.
07-11-2008 05:44 PM
Please look at the page on the manual that i have referred you to and match the wires according to the suggestions there. There are four analog channels and each has positive and negative terminals. The COM port is for the ground lead. Also look at the manual for your Vernier sensor for further information.
07-21-2008 08:59 PM
Thank Ipshita _C
The Vernier Sensor requires +5V . How I want to get it from NI cRIO 9215. My supervisor advise me to use NI-cRIO 9263 as the output. But I cannot find the manual. Can u help me?
07-22-2008 03:01 PM
07-24-2008 10:51 PM
07-25-2008 02:56 PM
10-08-2008 07:57 PM
i really want to make this project (ECG) but i try to understand what and how is the ECG works.
can anybody tell me how i can make this and i see there are some equations / formulas how can you know it and what is the equations / formulas cause i try to search it but i can't find it.
Please tell me all about...