11-30-2015 06:18 AM
Good morning all
please i need your help .
I have I2C Touch Panel i want to reading a Value from it .i coonected it with myrio with i2c protocol but i only read 255 array .
Datasheet below.. thank you
12-01-2015 10:34 AM
Hi Azou_LabVIEW,
I don't completely understand the problem that you are running in to. However, I think your thread might be better answered and should be posted to the myRIO forums, located in the link below, where you would most likely get more traffic on the thread. In this case I found a video online that runs through some of the basics of using myRIO and I2C. Good luck on your project!
Academic Hardware Products (ELVIS, myDAQ, myRIO) Discussion Forum:
http://forums.ni.com/t5/Academic-Hardware-Products-ELVIS/bd-p/10
NI myRIO: "LCD (I2C) demo" LabVIEW project:
https://www.youtube.com/watch?v=qbD31AeqOMk
----------------------------
Aaron F.
Applications Engineering
National Instruments