03-11-2015 05:38 PM
I was looking projects and I found this document on how to use LCD screens with LabVIEW, specifically on the myRIO platform. However, I was confused by the wiring schematic, since I am relatively new to using LabVIEW and the MyRIO platform. I understood the wiring diagram for everything except for J2. I did not know what J2 was. Could anyone explain what it is for me?
This is the document that I was looking at:
https://decibel.ni.com/content/docs/DOC-30485
Thank you in advance.
-J. Alfred
03-12-2015 05:41 PM
Hey there, it looks like the J2 connector is shown on the left side of the picture in that document. As for what that connector is actually for, I can't say. It looks like it may be just a breakout for additional pins from the myRIO.