FPGA board boot-up

[robete]

A student was trying to link up his program with the FPGA board using Xilinx and I think he deleted the boot-up sequence. It no longer boots up and goes through the boot-up cycle like it used to. Does anyone know how to re-install the sequence so that it cycles through the checks of the LEDs, RotClock, etc?

[Danny_Funk]

Hello robete,

What piece of National Instrument Academic Hardware are you working with?

The Getting Started page on our website shows how to set up hardware, and if you are working with one of CompactRIOs you can format the controller then reinstall software onto the RealTime controller through Measurement & Automation Explorer.

Regards,

Danny F