Problems with Wireless Mode myRio

[RicMBM]

When I connect the myRIO via USB to my laptop, I go over to http://172.22.11.2 and go to the network setting page.

Attached picture

the wireless mode is no longer a drop-down selection, and when I enter all the correct network name/password, the error message of "Could not save changes to target. One or more settings for wlan0 are invalid"

[RichieTheBard]

Hello it may be that this is a software corruption issue, as this is not a common issue that we have seen a lot. If you have access to any additional working myRIOs, you  could try creating an image from a working one to this one with the RAD utility.

http://www.ni.com/example/30986/en/

In a previous case I found, a special reset of the system helped with the problem, so that may be another option, however this requires a file that I can't share on a forum, so if the first option doesn't work or is not available for you, you can either create a support ticket, or send my a private message, so I can create one for you and we can look into that possibility

[RicMBM]

---

RichieTheBard escribió:

Hello it may be that this is a software corruption issue, as this is not a common issue that we have seen a lot. If you have access to any additional working myRIOs, you  could try creating an image from a working one to this one with the RAD utility.

http://www.ni.com/example/30986/en/

In a previous case I found, a special reset of the system helped with the problem, so that may be another option, however this requires a file that I can't share on a forum, so if the first option doesn't work or is not available for you, you can either create a support ticket, or send my a private message, so I can create one for you and we can look into that possibility

---

ok, i'll try the first option

[RicMBM]

it didn't worked, any suggestion?