NI ELVIS II+ Board Accelerometer Connections

[SamDinosaurous]

So I am trying to hook up an accelerometer to my ELVIS II+ board so that I can use the Data Logger to log the values from the accelerometer. However, I am unsure as to where I can connect the SCL pin on my accelerometer (Serial communication Clock) and the SDA pin (Serial Data I2C). Which port do I connect these to on the ELVIS board?

[beccamir]

SamDinosaurous,

You would connect them to any of the DIO lines. These would be on port 0. 

These digital lines must meet the requirements for I2C. If you are using an FPGA, this would most likely be the case.