09-08-2011 04:10 PM
Hello
Iam writing a digital boolean array from labview to the DIOs in the Elvis....Now iam trying to check whether Iam recieving the signals at DIOs....
I tried connecting the LEDs to DIO of the Elvis board but the LEDS do not light up.....I even used the Measurement and automation explorer to the change the state of the Digital outputs using the Test Panels and even with this I can not verify whether the signal is comming I tried connecting LEDs to it but still the leds not glow.. what should I do to check if Iam recieving the signal.
Thanks
09-09-2011 10:31 AM
I have answered this question in your other thread.
http://forums.ni.com/t5/Multifunction-DAQ/NI-ELVIS-DAQ-Digital-Out/m-p/1699334
Regards,
Matt M.